Raspberry Pi HAT Prototype Board
The PEB-D-RPI Expansion Board is designed to plug in to the phyBOARD-Zeta expansion interface and supports the 2x20 Raspberry Pi HAT header to facilitate rapid prototyping. The Raspberry Pi community has introduced a wide variety of add-on boards called HATs (Hardware Attached on Top). These readily available boards feature circuitry for LEDs, buttons, sensors, motors, displays, and more. By adding the PEB-D-RPI Expansion Board to your phyBOARD-Zeta you can leverage off-the-shelf add-on boards to accelerate the development cycle.
i.MX7: Raspberry Pi HAT Support with PEB-D-RPI Expansion Board
The following diagram describes the 40-pin Raspberry Pi HAT pinout supported on the PEB-D-RPI Expansion Board.
There are a wide variety of add-on boards available on the market that will plug directly into the 2x20 Raspberry Pi header supported on the PEB-D-RPI Expansion Board.
PHYTEC is supporting the following RPI HATs in software:
PCB Design Files:
Contact PHYTEC Sales to order hardware, learn about our product offering and capabilities, or for general questions. Call 800-278-9913 or send an email to firstname.lastname@example.org
Getting more help
Need support? Visit the PHYTEC Service Desk for technical support, product questions, Return Merchandise Authorizations, and more!
Sign up for new product announcements.
Need schematics? Visit the PHYTEC Service Desk and register to receive schematics.
Note: Raspberry Pi is a trademark of the Raspberry Pi Foundation